Ancillary services: what a battery system can earn in Ukraine
FCR, aFRR, mFRR and replacement reserve — which services the Ukrainian TSO buys, what each one demands of a battery, how the revenue is calculated and…

Beyond savings on your own bill, a battery can sell readiness to hold reserve capacity for the transmission system operator. It is a separate revenue stream with its own rules, equipment requirements and entry threshold. Here is what the services are, what they need and who they genuinely suit.
Key parameters
What the transmission system operator buys
Ancillary services are not the sale of electricity. They are the sale of readiness to change power on command or automatically, so that system frequency stays within limits. Payment is mostly for availability, not for delivered kilowatt-hours.
| Service | Abbreviation | Activation | Duration | Trigger |
|---|---|---|---|---|
| Frequency containment reserve | FCR / РПЧ | within 30 s | 15 min | automatic, on frequency deviation |
| Automatic frequency restoration reserve | aFRR / аРВЧ | within 5 min | up to 1 h | automatic, on the AGC signal |
| Manual frequency restoration reserve | mFRR / рРВЧ | within 12.5 min | up to 2 h | dispatcher command |
| Replacement reserve | RR / РЗ | beyond 12.5 min | longer | command, to free up other reserves |
A battery naturally fits the first two: it reaches full power in fractions of a second and follows a setpoint more accurately than a thermal unit. That is exactly why batteries took most of the FCR market in Europe.
Separately there are black start and voltage control services. For storage they remain exotic in Ukraine, but they exist formally.
What the battery has to be capable of
- Power
- Minimum participation is 1 MW. Smaller installations reach the market only through an aggregator that pools several sites into a virtual power plant.
- Power-to-energy ratio
- FCR requires holding full power for 15 minutes — 0.25 h of energy. aFRR requires up to an hour, i.e. 1C. mFRR up to two hours. A "1 MW / 500 kWh" system qualifies for FCR but not for aFRR.
- Symmetry
- Reserve is sold upward and downward. To offer both, the battery must sit near the middle of its SOC range, around 50 %. Which means tariff arbitrage cannot run on the same capacity at the same time: it is occupied.
- Telemetry and control
- A mandatory link to the dispatch centre, real-time parameter reporting and acceptance of a control signal. In practice: a dedicated controller, a secured channel and formal testing.
- Prequalification
- Before admission the equipment is tested: response to a frequency step, accuracy, sustained delivery. The procedure costs time and money before the first hryvnia is earned.
The practical conclusion: a typical 500 kW industrial battery installed for peak shaving will not reach this market. It is a different class of project — from a megawatt upward, with its own economics and its own lead time.
How the revenue works
Revenue has two parts: a capacity payment for every hour the reserve is available, and an activation payment for energy actually delivered or absorbed.
For a battery the first dominates:
Annual revenue ≈ Power (MW) × availability price per MW·h × hours per year × availability factor
Three caveats without which the formula misleads:
- The price moves. It is set at auction and depends on how much reserve others offer. More batteries in the system push it down — which has already happened in Germany and Britain, where FCR returns fell several-fold within a few years.
- Not every hour. You bid for specific periods and do not win them all. A realistic utilisation is 40–70 % of hours.
- Degradation. Reserve duty is many shallow cycles. They count against total cycle life, so the datasheet number has to be divided by the real duty profile.
Treating this stream as the basis of a payback case is therefore risky. The sound model: base the payback on peak shaving and arbitrage at your own site, and treat ancillary services as additional revenue that accelerates the return without underpinning it.
The calculator below gives an order of magnitude from your own assumptions about price and availability — assumptions, because auction prices are published after the fact and keep moving.
Day-ahead and intraday arbitrage — the second stream
- Day-ahead market (РДН)
- Trading for the following day in hourly steps. Prices are published in advance, so the charge and discharge cycle can be planned. Most arbitrage strategies live here.
- Intraday market (ВДР)
- Trading within the current day, correcting positions after generation or demand forecasts change. Prices are more volatile and the windows are short.
- Ancillary services market
- The segment where the reserves described above are traded.
For an industrial consumer, arbitrage is normally reached not directly but through the electricity supplier: you take an hourly tariff indexed to the day-ahead price, and the battery simply shifts consumption into the cheap hours. That needs no licence, no qualification and no telemetry — only an hourly tariff in the contract and an EMS that can act on a price forecast.
The spread between daily bands reaches 2–2.5× in practice, and on days with a renewable surplus the midday price falls to levels where charging is close to free. Real figures are in the dynamic tariffs analysis.
What it takes to enter the market
- Assess technical fitness. Power-to-energy ratio, the ability to hold SOC mid-range, an available telemetry channel.
- Choose the participation model. Directly — registration as an ancillary services provider and prequalification. Through an aggregator — faster and cheaper to start, but a share of the revenue goes to the aggregator.
- Bring the EMS up to standard. It must accept an external signal, keep a log and deliver the specified response. A standard industrial EMS does not do this out of the box — see the breakdown of EMS functions.
- Pass the tests. Frequency step response, setpoint accuracy, sustained delivery.
- Sign the contract with the TSO and start bidding.
A realistic timeline from decision to first revenue is six months or more. If the battery is still at design stage, the ancillary services requirements should be built in now: retrofitting telemetry and rewriting the EMS afterwards costs more than specifying it once.
If you are considering a project from 1 MW and want to know which revenue stream is primary in your case, describe the site in the questionnaire — the business goals block exists for exactly this.
Order of magnitude for ancillary revenue
The formula is simple, but every input is your assumption: auction prices are published after the fact and keep moving. The sliders give a range, not a forecast.
Revenue counts availability only, with no activation payment. CAPEX follows the site-wide price ladder for a one-hour system. Degradation from shallow reserve cycling is excluded and cuts cycle life by 10–20 % against the datasheet.
Frequently asked questions
What is the ancillary services market?
What is FCR?
What is the minimum size for participation?
Can one battery do both peak shaving and ancillary services?
How much can a battery earn on ancillary services?
What are the day-ahead and intraday markets?
How long does it take to enter the ancillary services market?
Figures shown are indicative. We supply the equipment and size the system; design, installation and commissioning are arranged through contractors when needed and quoted separately. Exact sizing follows a load-profile analysis.
Need equipment?
Request a quotation.
Send a model, specification or describe your requirements. We will clarify the configuration, check supply terms and prepare a price quotation.
